How to Install and Program an AirScape LCF Remote Control

***** NOTE: THIS POST ONLY APPLIES TO THE LCF VERSION OF THE REMOTE CONTROL ******

1. Plug the remote antenna into the control board 4-pin connection

2. Program the remote transmitter by cycling the power to the WHF off and on (unplugging and plugging in the power cord) or by pressing remote reset button

– A red LED on the control board will begin to flash indicating that the control board is ready to mate with your remote transmitter

– Press any button on the hand held transmitter

– The red LED will blink off

– Your WHF is now ready to use

3. Repeat this process to program additional remote transmitters